[vhdl-200x] Reminder: IEEE P1076-2008 Balloting

Reminder:
The draft for IEEE P1076-2008 is almost ready for IEEE balloting.

Please sign-up in IEEE myProject/myBallot if you wish to ballot -
see directions below.

Please note that if you signed-up prior to 2008, you will need to
re-sign up.  Sorry for the inconvenience, however, the previous ballot
group was over 6 months old and we were requested to reform the group.

You have until 31-May-2008, 11:59 p.m. Eastern Time to enroll.

Best Regards,
Jim Lewis
IEEE 1076/VASG chair


***** ENROLLMENT INSTRUCTIONS *****

Go directly to:

https://development.standards.ieee.org/my-site/open-ballot-invitations

Or, follow this process:

1. Log onto myProject; click the link for myBallot.
2. Click the link for myBallot Control Panel (if applicable); click the link for "Show/Join Open Ballot Invitations":
https://development.standards.ieee.org/my-site/open-ballot-invitations
3. Scroll down until you find the open ballot group of interest to you; then scroll over to the right margin and click
?join? under the ?Actions? column.
4. Select a classification category and click ?OK? at the bottom of the screen. You will receive an on-screen
confirmation that you successfully joined the group.

If you are not an IEEE SA Member, you can either enroll in a single ballot by paying a per-ballot fee or you can join
the IEEE SA by choosing an option link below. Joining the IEEE SA entitles you to participate in as many sponsor ballots
as you like for the year.

OPTION 1 - I am already an IEEE Member and I want to add Standards Association Membership. Go to:
https://myieeemembership.ieee.org/renewal/RenewalLogin
OPTION 2 - I am not an IEEE Member but would like to enroll in both IEEE and IEEE Standards Association. Go to:
https://webapps2.ieee.org/member/Member
OPTION 3 - I am not interested in becoming an IEEE Member, however I would like to enroll as a Standards Association
Member only. Go to: http://standards.ieee.org/sa-mem/join.html

============================================
OBLIGATIONS AND RESPONSIBILITIES OF BALLOTERS
============================================
Balloting group members are selected to vote on the acceptability of a new or revised standard, or on the reaffirmation
of a published standard submitted by the Sponsor; based on interest in and commitment to reviewing and voting on a
specific existing or proposed standard.

Once the document is ready to be balloted, you will receive notification via email. You will typically have 30 days to
review the document and return the ballot with your vote. By agreeing to participate in this ballot you have an
*obligation* to respond. Failure to return a completed ballot may disqualify you from participating in future ballots.



-- 
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Jim Lewis
Director of Training             mailto:Jim@SynthWorks.com
SynthWorks Design Inc.           http://www.SynthWorks.com
1-503-590-4787

Expert VHDL Training for Hardware Design and Verification
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.